The K&N Typhoon air intake system is a free-flowing, mandrel-bent aluminum tube air induction system designed to fit some Mini Cooper John Cooper Works, GP and Clubman models.
Fits the following models:
2011-2013 R56 JCW MINI Cooper S Hardtop
2011-2014 R55 JCW Mini Cooper S Clubman
2013 R56 R56 GP Hardtop
2012-2014 R58 JCW MINI Cooper S Coupe
2012-2014 R59 JCW MINI Cooper S Roadster
This product is CARB Approved for the following models only:
2011-2012 R56 JCW Mini Hardtop
2011 R55 JCW Mini Clubman
The restrictive factory air filter and air intake housing are replaced by the K&N Typhoon air intake which is designed to dramatically reduce air flow restriction as it smoothes and straightens air flow. This allows your engine to inhale a larger amount of air than the factory air intake. More air means more usable power and acceleration throughout the engine’s RPM range. The 69-2025TS air intake comes with a black rubber topped K&N high-flow air filter and a rectangular heat shield that installs into the previous air box space. Air is directed through the intake tube into the engine’s throttle body for a guaranteed power gain. The intake tube has an attractive silver powder-coat finish that's made to last and it accommodates the factory mass air sensor. The oversized cone shaped air filter can be used for up to 100,000 miles before servicing is needed depending on driving conditions. This air intake is relatively easy to install usually in 90 minutes or less using existing factory mounting points. The tools needed are a screwdriver, ratchet set and some wrenches.
- Guaranteed to increase horsepower
- Designed to improve throttle response and engine sound
- Low restriction aluminum tube
- Easy to install, usually in 90 minutes or less
- Lasts up to 100,000 miles before service is required (depending on driving conditions)
- Replaces stock air intake system
- Washable and reusable lifetime air filter
- K&N Million Mile Limited Warranty
- Street legal in most states (some not street legal in CA)
Gains of 6.03hp @ 5602 rpm and 4.64lb-ft @ 455 rpm. (Horsepower gains based on specific or similar vehicle dynamometer test. Results will vary.)
K&N Engineering, Inc., requires cleaning the intake system’s air filter element every 100,000 miles. When used in dusty or off-road environments, our filters will require cleaning more often. We recommend that you visually inspect your filter once every 25,000 miles to determine if the screen is still visible. When the screen is no longer visible some place on the filter element, it is time to clean it.