Fits the following JCW Cooper S models:
2007-2013 R56 JCW Cooper S Hardtop
2008-2014 R55 JCW Cooper S Clubman
2009-2015 R57 JCW Cooper S Convertibles
2012-2015 R58 JCW Cooper S Coupe
2012-2015 R59 JCW Cooper S Roadster
Select Front or Rear set.
These are performance street pads that produce slightly less dust than the factory pads while offering improved braking performance. Compatible with MINI brake wear sensors.
Premium street sport pad for cars up to 200bhp.
General spirited street driving.
Designed for premium street driving offering better brake effect up to 600°C (1100°F). EBC Greenstuff has a high initial brake effect and gives drivers confidence from first application of the brake pedal. There is no such thing as a NO DUST pad. The very nature of how a brake works requires that some dust be generated to avoid rotor vibration (shimmying). The EBC pad creates less dust and dust is more easily washed off than most. All pads create more dust as they are bedding in especially if rotors are worn. Nominal friction coefficient 0.55.
For faster cars and vehicles above 200bhp, or for greater dust reduction, we strongly recommend Redstuff.
These pads are coated with 'BRAKE-IN SURFACE COATING'.
[ ] Effective immediately after installation.
[ ] Conditions rotor surface.
[ ] Prevents early life noise.
[ ] Helps pads bed-in fast.
For stock MINI factory replacement JCW pads, see G2NMB2006.
Brakes are a safety critical part of your vehicle and should be installed by a competent mechanic following vehicle manufacturers installation procedure. The surface of these brake pads is coated with a red coating known as BRAKE-IN. This coating helps your newly installed brake pads to 'seat' or bed-in quickly. However, pads should be used gently for the first 100 miles until optimum braking is observed. Being a hard wearing pad, bed-in times can be as long as 1000 miles and drivers must be patient until the pad takes up the shape of their disc (brake rotor).
Rotors should be replaced with new when installing new brake pads. Failure to do so can result in brake noise as well as reduced braking efficiency. Avoid contamination of pad surface with any forms of grease that you may use to lubricate caliper sliders.
Manufacturers Warranty applies.
The entire green range is approved to ECE R90 for highway use.
Brake fluid should be replaced every 2 years, more often if you track your Mini.
For High Performance Brake Fluids, see the following:
For 'standard' replacement Brake Fluid, see Mini Cooper Brake Fluid Pentosin DOT4.
For non-JCW models, see G2NMB2022-P.
For the EBC Redstuff Ceramic Pads, see G2NMB2046-P.
For the Track rated EBC Yellowstuff pads, see G2NMB2048-P.