These are performance street pads that produce less brake dust than the factory pads while offering improved braking performance. These pads use Dupont® Kevlar® fibers which are stronger than steel. Compatible with MINI brake wear sensors.

Choose Model & Position from the pull-down menu.

Premium street sport pad for cars up to 200bhp.
General spirited street driving.

Designed for premium street driving offering better brake effect up to 600°C (1100°F). EBC Greenstuff has a high initial brake effect and gives drivers confidence from first application of the brake pedal. There is no such thing as a NO DUST pad. The very nature of how a brake works requires that some dust be generated to avoid rotor vibration (shimmying). The EBC pad creates less dust and dust is more easily washed off than most. All pads create more dust as they are bedding in especially if rotors are worn. Nominal friction coefficient 0.55. For faster cars and vehicles above 200bhp we strongly recommend Redstuff which DOES offer much less dust.

These pads are coated with 'BRAKE-IN SURFACE COATING'.
[ ] Effective immediately after installation.
[ ] Conditions rotor surface.
[ ] Prevents early life noise.
[ ] Helps pads bed-in fast.

For further reduction in brake dust, take a look at G2NMB2025 RED Ceramic Pads. For track use, G2NMB2026 YELLOW Track/Street pads.

For improved pedal feel, take a look at the Stainless Steel Braided Brake Lines.

For stock MINI factory replacement pads, see G2NMB2010.

Brake Dust

Some BRAKE DUST is inevitable from every brake pad and it is impossible to totally eliminate dust otherwise brake vibration will occur. We never advertise ZERO DUST we only advertise LESS DUST and we appreciate that in some cases dust will be almost the same as original pads. However, please note that dust is always more severe in the first 1000 miles of driving especially if pads were fitted to partly worn rotors. Another condition which promotes significant dust is wrong pad compound choice. If you have a car with over 200bhp (horse power) or drive above what we might call a spirited street level, for example green pads would not be suitable and red ceramic, being a slightly harder pad, can handle these higher speeds and loads and gives off less dust … there may be cases of overload where the Green pads are carbonising in use and a higher spec pad (Red Ceramic) is needed. Yellow compounds are a fantastic brake, probably our best but they are equal in dust to Original parts and should not be chosen if a low dust pad is what you need. Our CLEANEST pads are RED CERAMIC for sedans.

NOTE:
Brakes are a safety critical part of your vehicle and should be installed by a competent mechanic following vehicle manufacturers installation procedure. The surface of these brake pads is coated with a red coating known as BRAKE-IN. This coating helps your newly installed brake pads to 'seat' or bed-in quickly. However, pads should be used gently for the first 100 miles until optimum braking is observed. Being a hard wearing pad, bed-in times can be as long as 1000 miles and drivers must be patient until the pad takes up the shape of their disc (brake rotor).

Rotors should be replaced with new when installing new brake pads. Failure to do so can result in brake noise as well as reduced braking efficiency. Avoid contamination of pad surface with any forms of grease that you may use to lubricate caliper sliders.

Manufacturers Warranty applies.

The entire green range is approved to ECE R90 for highway use.

See ATE Super Blue for replacement brake fluid. ATE Super Blue is a high quality performance fluid that will last much longer than the standard DOT4 fluid. This is an ABS friendly fluid.

ATE® Super Blue has a dry boiling point of 536F and a wet boiling point of 396F which far exceeds standard brake fluids meeting the DOT 4 requirements. This fluid is NOT SILICONE and is compatible with conventional brake fluid. 100% synthetic fluid is specifically designed to resist the high temperatures of racing brakes and yet very suitable for daily driving.

Share