Resetting the Brake Wear Service Light

Save This
Page

When the Brake Wear Service indicator light illuminates, one of the two Brake Wear Sensors has been triggered.  The brake wear sensor is a wire loop that gets worn down against the rotor.  Once the wire is worn thru and the circuit is opened, the brake wear indicator light is illuminated.

The MINI has a brake wear sensor in the front left wheel, and the right rear wheel.

After replacing the worn sensor, reset the service light with the following procedure:

For Gen 1 2002-2006 R50 and R53 Hatchback and 2005-2008 R52 Convertibles

A.  Turn the ignition key to the #2 position for around 30 seconds without turning over the engine
B.  The light should go out! 

For Gen 2 2007+ R56 Hatchbacks, 2008+ R55 CLUBMAN, and 2009+ R57 Convertibles

To enter the service Menu:

A. Insert Key
B. Do not press clutch / brake
C. Press Start button
D. Wait until the Car / revelant Service symbol disappears on the Rev counter display
E. Immediately after the symbol goes out - Press and hold Both buttons on the Rev Counter
F. Continue to hold - the system Will run a dash light check
G. Continue to hold
H. Display will then show VIN / Menu, - continue to hold through this until the time Reappears on the display.
I. Now release Only the Right hand Button (trip reset) for about a second, and then press and hold again (whilst still holding the LH button)
J. After another second of 2 the display will show the Front Brake Symbol You Are Now in the Service Menu:D
K. Use the BC Button (on indicator stalk) to scroll through to the relevant symbol - eg Rear Brakes

L. To Reset the warning indicator light - Press & Hold the BC Button at the revelant symbol until RESET appears - then press and hold again until the process is complete.

Turn Off and On the Ignition again - Warning should now have gone!

Article Date: Jun 18, 2009
Car Accociations: NEW_MINI
Hits: 306