You can never change your oil too often - it's cheap insurance. Many people like to change their oil and filter in their brand new MINI at a very low mileage to eliminate any manufacturing residue that may have remained in the crankcase. Call it a 'final system flush' before you begin your normal routine maintenance.

Others feel the factory interval is too long and they change their oil and filter once if not twice between the recommended interval.

Includes the filter, O-ring, AND a new crush washer for the drain plug.

See G2NMK1056 for a non-factory alternative filter made by MANN Filters.

Remember to use Full Synthetic motor oil!

See G2NME1052 for the 27mm socket required to loosen the oil filter cap.

Torque oil filter cannister to 25Nm or 18 lb-ft, and drain plug to 30Nm or 22 lb-ft.

For 2007+ R56 MINI Cooper and Cooper S Hardtop and the 2008+ R55 MINI Cooper and Cooper S CLUBMAN.

Does NOT fit 2002-2006 Models.

Note: The factory recommends removing the intake snorkel to access the filter, but some have found that moving the reservoir tank aside without removing the lines is an easier way to get access. You decide!

It helps if you 'loosen' the oil filter cannister while you drain the oil to allow the oil to drain out of the filter. You will spill less oil this way. To access the filter cannister, remove the washer reservoir (1 bolt) but not the hoses, and move it aside. Before you press the filter into the cannister cover, press it into the filter base 'all the way' and remove to prep the filter for proper seating. Now you can press filter into the cannister cover and install. Remember to use the new O-ring on the cannister cover - put a little oil on the new oil ring so it doesn't bind. Start the cannister cover by hand to avoid cross-threading. Don't forget to use the new crush washer on the oil pan drain plug.