5% Off
800-946-2642
Shop by Car
Mini Cooper Brake Pads Ebc Red Front Set Gen3 Fxx Cooper S

Mini Cooper Brake Pads Ebc Red Front Set Gen3 Fxx Cooper S

Mini Cooper Brake Pads Ebc Red Front Set Gen3 Fxx Cooper S

Mini Cooper Brake Pads Ebc Red Front Set Gen3 Fxx Cooper S

Mini Cooper Brake Pads Ebc Red Front Set Gen3 Fxx Cooper S

Mini Cooper Brake Pads Ebc Red Front Set Gen3 Fxx Cooper S

Mini Cooper Brake Pads Ebc Red Front Set Gen3 Fxx Cooper S
Selected: G3NMB2050
Mini Cooper Brake Pads Ebc Red Front Set Gen3 Fxx Cooper S
Cooper S Front Set
Qty:
$125.10
Part No: G3NMB2050
SALE Price $125.10
List: $139.00
You save: $13.90
Select from variations below for more information:
Description

EBC Redstuff Ceramic 3000 Series Performance Front Brake Pads For Highly Tuned and Fast Street MINIs. Superstreet formula with significant dust reduction for Modified MINIs and fastest street driving.

Fits the following Mini Cooper S models:

2014-2020 F56 MINI Cooper S Hardtop
2015-2020 F55 MINI Cooper S Hardtop 4-Door
2016-2021 F57 MINI Cooper S Convertible

Fits the following Cooper non-S models:

2016+ F54 Mini Cooper non-S Clubman

Front pads are different for Cooper vs. Cooper S. The rear pads are the same for both Cooper and Cooper S. Select accordingly.

Description:

This material is an Aramid fibre based brake compound enhanced with ceramic particles. Updated from the previous generation pre-ceramic compound, this material is light years ahead. It lasts longer, it brakes better and is quieter. Being a hard wearing pad, bed-in times can be as long as 1000 miles and drivers must be patient until the pad takes up the shape of their disc (brake rotor).

This is a truly impressive fast road pad for repeated heavy braking. It emits far less dust than semi-metallic pads and has been proven to stop a passenger car/sedan/sport compact/hot hatch 13 metres quicker than OEM pads from 100mph/160kph. Features EBC Brake-In surface coating which conditions rotor surface and accelerates pad bed-in. Nominal friction coefficient 0.5 with approx. 50% dust reduction compared to other pads.

Features:

  • High Initial Brake Effect
  • Strong Resistance To Fade Under Load
  • Reduced Rotor Wear
  • Low Dusting Of Wheels
  • Shimmed; Chamfered; And Slotted
  • Features EBC Brake-In Coating For Fast Break In
  • Zero Noise And Extended Lifetime
  • Accepts factory brake wear sensor

These pads are coated with 'BRAKE-IN SURFACE COATING':

  • Effective immediately after installation
  • Conditions rotor surface
  • Prevents early life noise
  • Helps pads bed-in fast.

These pads will dust some during break-in, and maybe even 'squeal' a little - but the dust and noise will subside after break-in - the dusting will greatly diminish and the noise typically goes away after a few hundred miles. Use anti-squeal compound when installing for added prevention against squeal.

Brake Dust

Some BRAKE DUST is inevitable from every brake pad and it is impossible to totally eliminate dust otherwise brake vibration will occur. We never advertise ZERO DUST we only advertise LESS DUST and we appreciate that in some cases dust will be almost the same as original pads. However, please note that dust is always more severe in the first 1000 miles of driving especially if pads were fitted to partly worn rotors. Another condition which promotes significant dust is wrong pad compound choice. If you have a car with over 200bhp (horse power) or drive above what we might call a spirited street level, for example green pads would not be suitable and red ceramic, being a slightly harder pad, can handle these higher speeds and loads and gives off less dust … there may be cases of overload where the Green pads are carbonising in use and a higher spec pad (Red Ceramic) is needed. Yellow compounds are a fantastic brake, probably our best but they are equal in dust to Original parts and should not be chosen if a low dust pad is what you need. Our CLEANEST pads are RED CERAMIC for sedans.

NOTE:
Brakes are a safety critical part of your vehicle and should be installed by a competent mechanic following vehicle manufacturers installation procedure. The surface of these brake pads is coated with a red coating known as BRAKE-IN. This coating helps your newly installed brake pads to 'seat' or bed-in quickly. However, pads should be used gently for the first 100 miles until optimum braking is observed. Being a hard wearing pad, bed-in times can be as long as 1000 miles and drivers must be patient until the pad takes up the shape of their disc (brake rotor).

Rotors should be replaced with new when installing new brake pads. Failure to do so can result in brake noise as well as reduced braking efficiency. Avoid contamination of pad surface with any forms of grease that you may use to lubricate caliper sliders.

Manufacturers Warranty applies.

Brake fluid should be replaced every 2 years. See Mini Cooper Brake Fluid Pentosin DOT4 for high quality brake fluid.

For High Performance Brake Fluids, see the following:

Related Technical Articles:
Mini Cooper EBC Brake Pad Application Guide
Created: April 27, 2015
EBC produces high quality replacement and performance Brake Pads for the MINI Cooper. Whether your MINI needs routine maintenance or upgrades for track, EBC offers a solution to fit your needs. Choose from EBC Ultimax, EBC Greenstuff, EBC Redstuff, and EBC Yellowstuff Brake Pads
Customer Reviews
Recently Viewed Items